PowerSave 3200/3400™ Downloadable Brochure

PowerSave 3200/3400™ Installation Guide and Specifications

INSTALLATION OF PU 3200 & PU 3400 POWER SAVE UNITS

- Both units have 4 wires exiting the bottom through a "non-metallic connector"

- Both units can be installed as follows:

1. using flex conduit and connector feed the 4 wires (3 red and 1 green) to the panel and connect the 3 red wires to a breaker and the green wire to the ground bar

2. using a fused or non-fused disconnect box interface unit into electrical system

- When installing the 3200 use a 30 amp three pole breaker

- When installing the 3400 use a 40 amp three pole breaker

- In either method of install, and with both units, make certain the power is off until the unit is installed completely, then turn power on (throw the breaker on, or engage the disconnect box) and check to make certain light is on.

- If light is not on check breaker, ground, and disconnect box for secure connections

- Either unit will work in a 208/440 environment

SPECS FOR COMMERCIAL UNITS

Benefits:

-Reduces electricity required by existing inductive loads

- Enhances capacity of existing electrical system

- Eliminates danger of harmful power surges on appliances and sensitive electronic equipment

- Reduces harmful effects caused by electrical noise in the electrical system

Features:

- Electrical Noise Reduction

- Power Factor Optimization

- Voltage Regulation

Specifications:

THREE PHASE UNIT we call PS3200, sizes fractional motors up to 75hp

THREE PHASE UNIT we call PS3400, sizes motors 75hp up to 300hp

Both units are in NEMA 3 rated 7” X 7” X 8” enclosure